[Critter174]

they do make the clamps to fit yours as well. and when you go to tighten the screws down just hold the light where you want it or a little below that way when you snug it down it will be right where you want it
when your done it wasn't that hard. and if you want to make sure it is the same on both sides you could use a 4 ft level and put on top of them to make sure they are the same on both sides. also make sure the screws they send are the correct ones the ones i got were a course thread so i went to the dealer and got some chrome ones that was a fine thread and a correct fit. if you run into anything just give a holler.